I did a little reading and was curious if someone with knowledge could fill in the gaps for me. I recently had my slave cylinder replaced because it somehow broke while I was on vaca and with no tools. So I had AAMCO fix it. Now it seems like the clutch doesn't disengage until the clutch pedal is almost to the floor. I don't have any slippage in the gears so I don't think the clutch is going bad. But I was wondering if I bleed the clutch line if it would disengage closer to the stationary position? I can litteraly push the clutch a half inch and nothing happens. So I think those yahoo's at the shop were stoned enough to freaking mess something up... Thanks for the help.