Hey all, bunch of my friends and i last month swapped my atx to a mtx and i am having problems with my speed sensor. I bought a wire harness from someone and wired it up according to the how to on here but i wired it up according to the post i found on her along time ago and it does not work.
I did it like this... from sensor to lower plug on ecu -yellow ---- yellow -black/green ----- black/green -yellow/white ----- yellow/white
Now i also have a 97 and the trans computer is still hooked up and under the dash in front of the center column, does that need to be removed? I tried three different sensors on the car(all were used though) but before i go out and buy a brand new one i just want to make sure i am not overlooking anything.
I am getting two cels one for speed sensor and one for Solenoid.
thanks, kevin
___________________________________________________________________________ 13psi on a built bottom end with a stock now mtx, check mate.
Outside of Corona: "That sucks, peace out..." (jamie walks away)... "Sweeet, what we doin?" -Zac Tim's garage (prior to motor install): "Im gonna smoke real quick, that way if you fuck up I am already nicotined up" -Tim
#8485, "RE: ATX to MTX speed sensor problems" In response to Reply # 0
Yea, when I tried this the other day, I spliced those three wires like he did, and after that the car would just crank but not start for some reason. I have my TCU removed though. So now I'm driving with no speedo. Idk what I'm doing wrong but it doesn't seem complicated...