| Go back to previous topic |
| Forum name | Engine Management Systems & Controllers |
| Topic subject | Dynatek Arc-2 install Question |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=4572 |
4572, Dynatek Arc-2 install Question
Posted by bagged420a, Dec-31-69 06:00 PM
Has anybody already installed an Arc-2? If so, what did you connect/splice the black wires at? I hooked them up to the 12v running to the coil, is this correct?
|
4578, RE: Dynatek Arc-2 install Question
Posted by VelocitaPaola, Dec-31-69 06:00 PM
Cut the center wire leading to the coil pack (+12V). Connect both black wires from the ARC-2 to the end of the cut wire leading to the coil and connect the orange wire to the other end leading to the ASD relay. The rest should be pretty obvious.
|
4580, RE: Dynatek Arc-2 install Question
Posted by bagged420a, Dec-31-69 06:00 PM
Thanks. Thats what I did, just wanted to double check.
|