I was doing urethane motor mount DIY http://www.2gnt.com/www/corbin/mount.html
And for the lack of funds I only ordered one package of urethane from McMaster. I thought 5 packets per side would be enough. To make long story short, I run out of urethane and currently I am ordering another package. I would estimate that for the front motor mount you will need just under 7 packets per side and at least 2 packages of 10 will need to be bought. So please change this in the DIY so that people can order extra before they start.

I hear what you're saying, Gramz, but I'm not familiar with the packets linked in Corbin's write up. Personally, I've always used a single, large tube of the ultra fast cure 3M Window Weld. It doesn't cure in 5 minutes, but it will cure overnight. You might drop Corbin an email to share your comments with him, directly, as he's a pretty busy guy and might not see this thread for a while.

Thanks for your help. :thumbsup

I C ... I sent him a messege, hopefully he will agree with me.

I really only used 5 packets per side. I was very thorough with squeezing every last molecule of material out of the packets. I also only filled the mount up to what is shown in the pictures. You could put more in. I will add a note about ordering extra material, just in case.

Corbin

'95 ESI-T
Now with more power and fewer leaks



Gimme fuel...Gimme fire...Gimme that which I desire

I did squize out every last drop and the gap is bout 3/4 full :-( but not to worry the new shippment already came in.

Thanks for quick response