Go back to previous topic
Forum namePerformance/Engine
Topic subjectRE: crank pulley install
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=138385&mesg_id=138387
138387, RE: crank pulley install
Posted by J, Dec-31-69 06:00 PM

Alright, do this.......

Take the pulley, and put it in the oven @ 500' (however high it goes)... get some gloves (like for a grill), pull it out of the oven once its been heated up, and it *will* just slide right onto the crank like butter! It goes on very, very easy... and then you can take your block and make sure it's hammered on straight. You just want to make sure it's lined up w/ your other pulleys, that's all :)

- J

I generated this page in 0.0090770721435547 seconds, executing 6 queries.