I have a folder on my harddrive for eveything I will do/have done to my car, and guess what here are the instructions which were provided to me by Armond30:

Power wire: oversized Black wire with White stripe. pin 20 should be the
extreme bottom on the upper connector for the ECU. second row of 4.
Tach signal (RPM): White Wire Pin 73 should be 3rd pin from top on an extreme side of the BOTTOM ECU connector.
Throttle sensor (TPS): brown wire with red stripe. pin 35 should be close
to the middle of the extreme side (length ways) of the top ECU connector
Ground: black small wire. pin 10. should be in an extreme bottom corner of the TOP ECU connector
pressure sensor (MAP): yellow wire with BLACK stripe. pin 36 should be
directly beside the TPS signal wire.
use the wiring diagram for cars equipped with pressure sensor in the
instructions. all unused wires should be tied off. They are for skyline.

Pressure sensor is type 6 (6 in 6 out)

throttle arrow should be pointing up.

that should be all you need to get going.


Skrilla
'97 Base Talon NA
"Technology is the Only Substitute for Displacment"
"Peace and Turbo Grease"