Go back to previous topic
Forum namePerformance/Engine
Topic subjectRE: head gasket..
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=295&mesg_id=296
296, RE: head gasket..
Posted by MWC, Dec-31-69 06:00 PM
I did it, and the hardest part of it was the Underdrive pulley. :(
I ended up paying a shop to remove it and put the timing belt on, but since it is like a timing belt change they charged me $300. That hurt, but I rented the special puller from Mitsubishi and the damn thing still would not budge. I know there are others on the board that did this and had no problem, so its prob just me and my luck. :)
As far as directions I would suggest you buying a haynes manual if not the factory one from the dealer. Good Luck
SEE YA!!!!!!!!!!MWC










http://smkn95eclipsemwc.homestead.com/mainpage.html




I generated this page in 0.010296821594238 seconds, executing 6 queries.