Go back to previous topic
Forum nameManual Trans - NV-T350
Topic subjectRE: no start after m/t swap
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=34&topic_id=8811&mesg_id=8815
8815, RE: no start after m/t swap
Posted by CODE4, Dec-31-69 06:00 PM
Originally posted by Slimyjr.
Well the black/yellow wire going to the solenoid is a ground isn't it? The starter is getting power, so i ran a jumper from the neg on the batt. to the neg post on the solenoid so i knew it was being grounded.


The black/yellow wire to the solenoid is +12 volt feed from the starter relay. Refer to the Service Manual wiring diagram for wiring colors and such.
I generated this page in 0.0075230598449707 seconds, executing 6 queries.