http://www.imagestation.com/album/?id=4290345995

I remember you saying that you saying that your gear slect lever broke off and you put in a bolt to replace a roll pin. I got the roll pin from the dealer but it seems as though it will fall out in a while cuz I can just push it in and out with my finger. Do you think it would be OK? to use JB weld or something so it won't come out? OR is there a proper way to do it?

thanks.

if you can push it in and out with your finger don't use it. It should be tight like hardly any movement actually no movement at all if you use the roll pin. Either do what I did and buy a bolt and locking nut that fits through the hole pretty well or put that pin in and weld it. DOn' tknow if JB weld will work but the force distrobution will be on the weld itself only then and it may crack. if the roll pin was the right size it's like REALLY hard to get in there.

thanks alot man,

I really appriciate it.