| Go back to previous topic | |
| Forum name | Manual Trans - NV-T350 |
| Topic subject | And the motherlover went.... |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=34&topic_id=104 |
|
104, And the motherlover went.... Posted by DSMRoadster, Dec-31-69 06:00 PM Well the past couple of days I've been hearing strange clunking and minor booms from somewhere in the engine bay everytime I take off slowly. Turbo+rebuilt engine+CM stage 4+12psi=extreme wheel hop=bye bye tranny. All this with only 63k original miles on a 97 and 6k miles on rebuilt engine. Another factor I believe, is because I didn't have the rear engine mount secured to the car. I was bar hopping last night and had my lil brother come pick up the car for me and drive it home. I went to get the car ready for him. I put it in reverse to get it out of the parking lot and it wouldn't go. I take it out of gear and put back in reverse again and it went. My little brother get's about 3 miles on it. He hits a pot hole and that's where he heard the final noises and sees metal pieces and fluid falling from my car. There's the about a hand size piece witht the tranny fluid drain plug attached to it and some gears that dropped out. I'll take pictures later. Now I needs to do some tranny shopping. Anyone know what the expected price would be for a used one? | |
|
105, RE: And the motherlover went.... Posted by 420AYE, Dec-31-69 06:00 PM that sucks! hope you can take out a big loan or are a rich rapper. | |
|
107, RE: And the motherlover went.... Posted by DSMRoadster, Dec-31-69 06:00 PM nah, I have money saved up. | |
|
108, RE: And the motherlover went.... Posted by Fast420A, Dec-31-69 06:00 PM If your a high HP guy, I would recommend going with the Neon SOHC swap with a 2GNT bellhousing. The 3.55 Final drive and the .72 5th gear will make a good combo for less wheel spin off the line and high overall MPH. | |
|
110, RE: And the motherlover went.... Posted by DSMRoadster, Dec-31-69 06:00 PM I guess it's time for me to learn about the tranny. What does the bellhousing look like and what does it do? Is switching the bell housing something I can do on my own? Don't forget the only thing that I didn't do on my own was getting block bored, head milled and crank polished. Other than that everything else was from reading and you guys here on this board. | |
|
115, RE: And the motherlover went.... Posted by Fast420A, Dec-31-69 06:00 PM Read here towards the bottom. | |
|
116, RE: And the motherlover went.... Posted by DSMRoadster, Dec-31-69 06:00 PM since the area around the drain plug that blew off and a couple of gears are well sitting on the garage floor, I believe the differential just decided to throw a party and things just got a littlw rowdy. But thanks man, Armond's page just enlightend me on quite a few things. | |
|
125, RE: And the motherlover went.... Posted by Fast420A, Dec-31-69 06:00 PM The differential's LOVE throwing rowdy parties! I still have yet to take the last tranny I blew apart but the hole is directly below the differential right in the bell housing. I should take it apart to see what gave. | |
